EyeLink Tracker Setup¶
Available on macOS
Prepare for calibration and launch the setup screen of an EyeLink Device.
Before launching the setup screen, this action sets the tracker’s
gaze-position coordinate system (via EyeLink’s
command) to match the coordinate system used on MWorks’ main stimulus
display. It then sets the calibration type (as specified in
calibration_type), so that the tracker recomputes the positions of
fixation targets in the new coordinate system.
Once the EyeLink setup screen has been launched, the user can manually initiate calibration, validation, or drift correction via the EyeLink host PC.
This action can be executed only when the EyeLink device is stopped (i.e. before the experiment invokes Start IO Device on it, or after it invokes Stop IO Device). Execution continues until the user manually exits the setup screen on the EyeLink host PC.
Name of EyeLink device
Desired calibration type
Allowed at top level:
Block, Conditionally Execute Actions (if), List, Protocol, Render Actions, Repeat Actions (while), Schedule Actions, Task System State, Trial, Unconditionally Execute Actions (else), Variable